Single/Quad/Auto Mode; Starting/Terminating Recording Manually; Reset - Conrad Electronic Sygonix 1486624 Notice D'emploi

e) Single/Quad/Auto Mode
The screen/DVR offers different display modes for the camera images. To switch between the display modes, briefly
push the button "QUAD" (6) several times.
Unused channels can be deactivated in the OSD menu (e.g. if you only operate two cameras at channels
1 and 2, channels 3 and 4 can be deactivated).
• Mode 1
The images of all 4 radio cameras are displayed at the same time and at the same size (Quad-View). This operating
mode is automatically active after activation of the screen/DVR.
• Mode 2
The image of radio camera/channel 1 is displayed. Use the control button "
different radio camera.
• Mode 3
The image of radio camera/channel 1 is displayed in the left area of the LC display (large image); the images of the
other radio cameras appear smaller at the right edge.
Briefly pushing the control button "
played in large.
If you briefly push the button "LOOP" (19), the screen/DVR activates the automatic change of the camera images
(channels). The display duration until the change can be set in the OSD menu. Push the button "LOOP" (19) again to
switch off automatic change again.
f) Starting/terminating recording manually
To permit a recording, either an SD-/SDHC-memory card must be inserted or a USB data carrier must be
connected. The corresponding memory type also must be selected in the OSD menu.
• If required, first use the control buttons "
the image.
• Briefly push the "REC" (18) button to start or stop the recording.
When a recording is running, the display shows the icon "
During manual recording, do not push any button (e.g. calling the OSD menu), since this may terminate the
recording.
g) Reset
To reset the screen/DVR, push the recessed button "RESET" (16) e.g. with a toothpick. All settings are lost.
64
" or " " permits choosing which camera image (or which channel) is dis-
" or " " to choose the radio camera from which you want to record
" or " " to manually switch to a
".