Assembly - GOK Caramatic DriveTwo Instructions De Montage Et D'utilisation

Crash sensor function
Activated crash sensors
 Flow rate free
Operation while driving using the integrated mechanical crash sensor which blocks
the gas flow in case of an accident with deceleration of 3.5g ± 0.5g, directly affecting
the trigger element; with an average vehicle weight this corresponds to crashing into
a solid obstacle at about 15 to 20km/h.

ASSEMBLY

Before assembly, check that the product is complete and has not suffered any damage during
transport.
ASSEMBLY must be carried out by a specialised company.
See USER QUALIFICATION!
The specialised company and the operator must observe, comply with and understand all of
the following instructions in this assembly and operating manual. For the system to function
as intended, it must be installed professionally in compliance with the technical rules
applicable to the planning, construction and operation of the entire system.
Consider installation location and installation position (see instructions on INTENDED USE).
Risk of injuries due to blown-out metal chips!
Metal chips may cause eye injuries.
Wear safety goggles!
Malfunctions caused by residues!
Proper functioning is not guaranteed.
Visually check that there are no metal chips or other residues in the connections!
It is important that metal chips or other residues are blown out!
Install with suitable tools, if required.
Regarding screw connections, use a second spanner to brace against the connection nozzle.
Do not use unsuitable tools, such as pliers.
Product damaged through incorrect installation direction
Proper functioning is not guaranteed.
Observe the installation direction (marked on the product with an arrow
22 / 44
Caramatic DriveTwo
Triggered crash sensors
 Flow rate blocked
).