Janome 1110DX Pro Livret D'instructions page 46

3
4
4
6
5
6, 7
1
3
B
5
8
7
2
3. Hold the thread at both ends and tug gently to ensure
the thread is correctly inserted between the tension
discs. (If the presser foot lifter is raised, the thread
easily inserts between the tension discs.)
3 Upper looper thread tension dial
4. Hook the thread on the corner B , and then pass
the thread through the looper thread guide.
4 Looper thread guide
5. Pass the thread through the looper thread
take-up lever (upper).
5 Upper looper thread guide (1)
6 Looper thread take-up lever (upper)
6. Pass the thread through upper looper thread
guide (2).
7. Holding the end of the thread with a pair of
tweezers, pass it through the hole on the upper
looper. Pull 10 cm (4˝) or more of thread through
the hole.
7 Upper looper thread guide (2)
8 Upper looper
To retread the upper looper
Turn the handwheel toward you until the upper looper
comes to the middle point of its travel, and unhook the
thread of the lower looper from the upper looper.
Thread the upper looper.
1 Lower looper thread
2 Upper looper
44