Troubleshooting Guide; Warnings - Unitron telecommande 2 Mode D'emploi

Troubleshooting guide

You can refer to the troubleshooting table below if
you are experiencing problems with your remote
control. For problems with your hearing aids, please
consult your hearing aid guide.
Cause
Indicator light not working
Not turned on
Low/dead battery
Poor battery contact
Battery upside down
Indicator light is yellow or red
Low battery
Hearing aids not responding to remote control
commands
Holding the remote
too far away
For any problems not listed in the guide, contact your
hearing healthcare professional.
14
Possible remedy
Turn on
Replace battery
Consult your hearing
healthcare professional
Insert battery plus (+) side up
Replace battery
Move the remote a maximum
distance of one arm's length

Warnings

Please read the information on the following
pages before using your Unitron remote
control.
Hazard warnings
Keep this device out of reach of pets and
children under 3 years.
Only use hearing aids that have been
specifically programmed for you by your
hearing healthcare professional.
Changes or modifications to any of the
devices that were not explicitly approved by
Unitron are not permitted.
This remote control uses low-power,
digitally coded transmission to
communicate to your hearing system. For
persons with active implantable medical
devices (i.e. pacemakers, defibrillators, etc.)
caution should be exercised when using this
device.
Dispose of electrical components in
accordance with your local regulations.
15