Lighted Key Pad; Page/Handset Locator; Channel Operation; Security Code - Clarity 435 Guide De L'utilisateur

Last Number Redial:
The last number dialed (up to 22 digits) is
stored in the redial memory until another
number is dialed.
To use this feature:
1. Press the TALK button.
2. When you hear the dial tone, press
the RD/P button.
3. The phone will automatically
dial for you.
Pause Feature:
Programming in a pause will cause the
phone to wait four (4) seconds before
dialing additional numbers. This feature
may be used when it is necessary to dial
an access code (9, for example) and
wait for a second dial tone before you
can dial an outside number. Press the
RD/P button at the required point during
the memory storage process to program
a pause.

Lighted Key Pad

The key pad will light for fifteen (15) seconds
after removing the handset from the base. To
reactivate the feature while in standby, press
the TALK or the MEM button. To activate while
the phone is in use, press any key.

Page/Handset Locator

To send a page signal from the base to the
handset, press the PAGE button located on
the base of the telephone. A series of rings
will sound from the handset.
Operating Your Telephone
To locate the handset if it is away from the
base, press and hold the PAGE button for
approximately five (5) seconds. A series of
rings will sound for approximately six (6)
seconds. Return the handset to the base or
press the TALK button to cancel the page.

Channel Operation

When pressed, the channel (CH) auto-
matically searches and selects the clearest
of 40 channels.

Security Code

The security code prevents your cordless
phone conversations from being accessed
by a phone on a different line. Once the
handset battery is fully charged, the handset
will automatically select the code from
over 65,000 different combinations. The
code is changed every time the handset is
placed in the cradle.
If you have trouble with placing or receiving
calls, a lost security code may be the cause
of the problem. When this occurs, the hand-
set can no longer communicate with the
base. Reset by placing the handset on the
base for 5-10 seconds. If that does not work,
unplug the AC adapter from the wall outlet.
Disconnect the handset battery for 5-10
seconds, and then reconnect. Place hand-
set back on the base and then reinsert the
AC adapter.
E
N
G
L
I
S
H
13