Installation Of The Monitor - Luda Elektronik IWT Horse & Trailer Cam Guide D'utilisation

6. Installation of the monitor

As we need to be able to view the angle of the picture while installing the camera,
the monitor needs to be fitted first. Start fitting the monitor by following the steps
below.
1. Remove the protective plastic from the suction cup. Press the suction cup
against the inside of the windshield and secure it by pressing the lever (towards
the windshield).
2. Mount the black antenna on the backside of the monitor.
3. Slide the monitor onto the suction bracket.
4. Connect the Lighter socket adapter to the monitor and then to the vehicle lighter
socket (12-24V).
5. Turn on the ignition of the car. Press the ON/OFF button (on the top of the
monitor). As the camera is not yet installed no image will show up on the screen
at this point. The channel indicator will light up in blue when the monitor is
supplied with power.
6. Turn the monitor off and continue to the next step, Installation of the battery
pack and camera.
Warning
The monitor must be positioned so that it may be observed by a front
seat passenger and does not distract the driver in any way when
used on the road.
- 13 -
eN
De
Fr