Installation Of The Monitor - Luda Elektronik trailerCam Guide D'utilisation

6. Installation of the monitor

To be able to view the angle of the picture while installing the camera, the monitor needs to be fitted
first. Start fitting the monitor by following the steps below.
1. Remove the protective plastic from the suction cup. Press the suction cup against the inside of the
windshield and secure it by pressing the lever (towards the windshield).
2. Mount the black antenna on the backside of the monitor.
3. Slide the monitor on to the suction bracket.
4. Connect the Lighter socket adapter to the vehicle's lighter socket (12-24V) and to the monitor's
power socket.
5. Turn on the ignition to power up the monitor. Press the ON/OFF button (on the top of the monitor).
Since the camera is not yet installed no image will show up on the screen at this point. If the
monitor is switched ON the channel indicators will illuminate with a blue light.
6. Turn the monitor off and continue with the installation of the camera.
Warning
The monitor must be positioned so that it may be observed by a front seat passenger
and does not distract the driver in any way when used on the road.
If you run into problems with the camera, see Troubleshooting, chapter 8 and 9.
- 31 -
DE
EN
FR
SV