Safety-Conscious Work; Safety Information For The Operator/Operating Personnel; Safety Information For Installation, Maintenance And Inspection Works; Unauthorised Reconstruction And Production Of Spares - ITT MX 10 Instructions D'installation Et D'entretien

MX 10-M 15 20.10.2006 10:35 Uhr Seite 28
english
28
In detail, non-compliance, for example, may result in the
following risks:
- failure of important functions in the plant
- failure of prescribed methods for servicing and maintenance
- danger to persons through electrical and mechanical causes

1.5 Safety-conscious work

The safety information contained in these installation and
operating instructions, the existing national regulations for the
prevention of accidents, as well as any internal working,
operating and safety regulations stipulated by the operator
must be observed.

1.6 Safety information for the operator/operating personnel

Any risks from electric power must be eliminated (For details
see, for example, the regulations published by NIN (CENELEC)
and the I.E.E.).
1.7 Safety information for installation, maintenance
and inspection works
The operator has to ensure that all installation, maintenance
and inspection works are carried out by authorised and qualified
specialist personnel who have informed themselves adequately
about the requirements by a thorough study of the installation
and operating instructions.
Basically, any works on the plant should only be carried out
when it is at a standstill and not carrying any electrical current.
Directly after completion of the works, all safety and protective
installations must be mounted or activated again.
Before re-commissioning, the points listed in the section
«Electrical connection» must be observed.

1.8 Unauthorised reconstruction and production of spares

Reconstruction of or changes to pumps are only permissible
after consultation with the manufacturer. Genuine spare parts
and accessories authorised by the manufacturer serve the cause
of safety.
The use of other parts can cancel any liability for the resultant
consequences of this.

1.9 Improper operating methods

The operating reliability of the pumps supplied is only
guaranteed with appropriate application of the section
«Intended application» of the Installation and Operating
Instructions. The limit values given in the technical data must
not be exceeded on any account.