Festo CP FB8 Notice Simplifiee page 12

CP FB8
2
Configuration
PLEASE NOTE
The cover is connected to the internal PC boards via the
operating voltage cable. It cannot therefore not be removed
completely.
CAUTION
The node contains elements which are liable to damage by
electrostatic charges. The node can also be destroyed if the
contact surfaces of plug connectors are touched, or if the
regulations for handling electrostatically vulnerable compo-
nents are not observed.
Please observe the following when configuring:
1. Switch off the operating voltage.
2. Open node (screws are liable to be lost).
3. Set fieldbus address.
4. Set fieldbus baud rate.
5. Close node.
6. If the CP system to be connected is at the end of a
fieldbus line, a terminating resistor must be installed.
12
9809c