KRUPS Espresseria Automatic
6 Troubleshooting
If your machine is not operating correctly,
try to resolve it by referring to this trou-
bleshooting guide. If the problems persist
in spite of this, contact our hotline (see
chapter 10).
Problem
The appliance does
not switch on when
the ON/OFF button
is pressed.
The espresso or cof-
fee is not hot en-
ough.
The coffee is too
lightly coloured or
too weak.
The coffee dis-
penses too slowly.
The coffee is not
creamy.
You have accidentally used ground coffee instead of coffee
beans.
32
Probable causes
Power failure or blown fuse.
The mains plug is not pushed into
the mains socket correctly or the mains
socket is faulty.
The appliance is faulty.
The temperature of the coffee is not
set high enough.
The coffee cup is cold.
There is not enough coffee in the
coffee bean holder (15).
The coffee is too coarse.
Too much coffee is prepared.
The coffee is too fine.
The coffee is too coarse.
The coffee is not fresh.
.
Use and maintenance / SERIE EA 80xx
Danger :
Only a qualified technician
is authorised to carry out repairs on the
power cord and the 230 V electrical sys-
tem. Failure to respect this exposes you
to fatal injuries due to the presence of
electricity !
Do not use an appliance that is visibly da-
maged !
Corrective actions
Check the fuses of your electri-
cal installation.
Check that the plug is correctly
inserted into the socket or have
the socket repaired.
Have the appliance checked by
a qualified technician.
Check the temperature of the
coffee in the "Settings" menu.
Warm the cup by rinsing it
with hot water before starting
the preparation.
Add coffee beans to the hol-
der.
Use the grinder setting button
(13) to obtain a finer grind.
Reduce the quantity of coffee
using the knob (3).
Use the grinder setting button
(13) to obtain a coarser grind.
Use the grinder setting button
(13) to obtain a finer grind.
Use fresher coffee beans.
Suck out the coffee in the cof-
fee bean holder with your va-
cuum cleaner.