Removing The Sticker From The Knife Head; Operation; Adjusting The Cutting Length; Switching The Device On And Off - Heiniger OT11 Notice De Service

1. Check conformability between the mains voltage on the nameplate of the
plug-in power supply unit [4] and the available current.
2. Insert the plug-in power supply unit into the socket.
3. Move the On/Off sliding switch [6] to position 0.
4. Pull out the comb attachment [3] from the device.
5. Place the device in the charger [10].
The LED charge level indicator [8] displays the charging status:
LED
Blinking
Glowing

Removing the sticker from the knife head

Pull out the sticker on the underside of the knife head before using it for the
first time. On this sticker, you can see whether the knife head can be folded
without using tools.
Charging status
Charging.
Charging is complete.

Operation

Adjusting the cutting length

Without comb attachment
Without comb attachment, the cutting length is 0.3 mm.
With comb attachment
The adjustable comb attachment [3] locks into the knife head [5] in 4 stages
from 3 to 6 mm.
Before cutting, check whether the desired cutting length has been set properly.
Use only original accessories.

Switching the device on and off

Actuate the on/off sliding switch [6].
Switch position
0
1
Operation
Device status
The device is switched off.
The device is switched on.
25