Consideration For Installation - Aprimatic AP424 Notice D'installation Mécanique, D'utilisation Et D'entretien

CONSIDERATIONS FOR INSTALLATION
•
The installation and testing operations must be performed solely by qualified personnel in
order to guarantee the proper and safe operation of the automatic gate.
•
The company declines any responsibility for damage caused by incorrect installations due to
incompetence and/or negligence.
•
Before assembling the automatism, check that the gate is in perfect working order, hangs well
on its hinges and is suitably lubricated. It must also comply with the safety standards in force in the
country of installation..
INSTALLATION
1- Before fastening the brackets provided, establish the coordinates using the data given in
Table 1, bearing in mind that they are valid if the operator is at maximum extension minus one
centimetre of the available stroke (CD) when the gate is closed to obtain maximum working
efficiency.
2- Data B in the table, with reference to the single values A, are to be considered as values
(recommended).
3- To anchor the piston, use the fastening brackets provided.
COORDINATES AND TABLE
1- Establish coordinates A + B that are
to be used.
2- Note: The stroke used (Cu) of the
Operator must never be equal or
greater than the available stroke (CD).
3- The sum of coordinates A + B,
establishes the stroke used Cu .
TABLE 1
Note 1: A+B = Cu (Stroke used)
AP424 / AP423
CD = (Available stroke) = 400mm
14