Fagor 6H-760 BX Manuel D'installation Et D'utilisateur page 15

5 / WHAT TO DO IF YOUR OVEN MALFUNCTIONS
If you have a doubt about the correct functioning of your oven, this does not
necessarily mean that there is a malfunction. In any event, check the following items:
YOU OBSERVE
THAT...
The oven is not
heating.
The oven light is not
working.
The pyrolysis cleaning
cycle does not begin.
Your oven starts
beeping.
The cooling fan
continues to operate
after the oven stops.
Warning
- Repairs to your appliance should only be performed by professionals. Non-standard repairs
may be a source of danger for the user.
Tip
In all circumstances, if your efforts are not sufficient, contact the After-Sales Service
Department without delay.
POSSIBLE
CAUSES
- The oven is not connected to
the power supply.
- Your fuse is out of order.
- The selected temperature is
too low.
- The light is out of order.
- The oven is not connected or
the fuse is not working.
- The door is not properly
closed.
- The locking system is
defective.
- During cooking.
- At the end of a cooking
cycle.
- The fan should work for a
maximum of one hour after
cooking, or when the oven
temperature is greater than
125°C.
- If it does not stop after 1 hour
15
WHAT SHOULD YOU DO?
➡
Plug in your oven.
➡ Replace the fuse in your
electrical set-up and check its
capacity (see table, section
"cable/fuse cross-section").
➡ Increase
the
temperature.
➡ Change the bulb.
➡ Plug in your oven or change the
fuse.
➡ Check that the door is locked.
➡ Call the After-Sales Service
Department.
➡ The recommended temperature
of your choice has been reached.
➡ Your programmed cooking
cycle is finished.
➡ Open the oven door to
accelerate the cooling down of the
oven
➡ Call the After-Sales Service
Department.
99645831 04/08
EN
selected