Ottobock 17B46 Serie Instructions D'utilisation page 13

Replacing the ball bearing
NOTICE
Canting the ball bearing
Mechanical damage
► Do not cant or damage the ball bearing while inserting it into the orthot­
ic joint.
1) Loosen the screws and disassemble the orthotic joint.
2) Remove the ball bearing from the orthotic joint and replace it with a new
one.
3) Assemble the orthotic joint and tighten the screws.
4) For the final assembly, secure the screw connection with Loctite 241.
8 Disposal
Dispose of the product in accordance with national regulations.
9 Legal information
All legal conditions are subject to the respective national laws of the country
of use and may vary accordingly.
9.1 Liability
The manufacturer will only assume liability if the product is used in accord­
ance with the descriptions and instructions provided in this document. The
manufacturer will not assume liability for damage caused by disregarding the
information in this document, particularly due to improper use or unauthor­
ised modification of the product.
9.2 CE conformity
The product meets the requirements of Regulation (EU) 2017/745 on medic­
al devices. The CE declaration of conformity can be downloaded from the
manufacturer's website.
1 Avant-propos
INFORMATION
Date de la dernière mise à jour : 2021-05-07
► Veuillez lire attentivement l'intégralité de ce document avant d'utiliser le
produit ainsi que respecter les consignes de sécurité.
► Apprenez à l'utilisateur comment utiliser son produit en toute sécurité.
Français
13