Adjustment Of Film Opening Bar; Sealing Frame Height Adjustment; Packaging - Minipack-Torre Pratika 56CS Instructions Pour L'installation, L'emploi Et L'entretien

Chapter 6. Machine adjustment and setting up

6.5.5. Adjustment of film opening bar

The bar (A1) allows to separate the 2 edges of the film reel.
Position the bar inside the 2 edges of the film so that the end is 1
cm behind the crease of the film.
Note: See chapter 6.4: PHASE 1

6.5.6. Sealing frame height adjustment

In order to get a good packaging the sealing frame should be
positioned in such a way, that the film welding is made at half the
packaging height.
To raise or lower the sealing frame:
-) Press the button (9)
-) Press the button START (13)
-) Press simultaneously the buttons (9)
to raise the sealing frame.
-) Press simultaneously the buttons (9)
to lower the sealing frame.

6.6. Packaging

Once all adjustments have been made, the machine is ready to
start working.
Place the machine in STOP AUTOMATIC mode.
Press the button START (13)
be packed on infeed conveyor.
and choose the MANUAL mode.
and (11)
and (12)
and position the products to
39
GB