Chapter 7. Ordinary Maintenance; Precautions And Setting To Maintenance Mode; Maintenance Table; Routine Maintenance Plan - Minipack-Torre Pratika 56CS Instructions Pour L'installation, L'emploi Et L'entretien

Chapter 7. Ordinary maintenance

7.1. Precautions and setting to maintenance mode

CAUTION!

Maintenance must be performed exclusively by skilled personnel familiar with the machine.

Never carry out maintenance, lubrication, or repairs when the machine is in operation and/or
connected to the power supply.

Never carry out maintenance on moving parts.

After maintenance re-fit all guards to restore normal operating conditions.

Always observe all safety standards as specified in this manual and these currently applied in the
country of installation.
SETTING THE MACHINE TO THE MAINTENANCE MODE
This procedure must be performed before all routine maintenance,cleaning and special maintenance, to shut off the
machine from all power sources, as follows:

Press the STOP button (14) (if the machine is running)

Switch the machine off by rotating the main switch (Q1) to "0" (OFF)

Remove the plug from the mains socket

Disconnect the pneumatic system by removing the hose from the compressed air system from the coupling on the
filter unit (see chapter 5.5.)

7.2. Maintenance table

7.2.1. Routine maintenance plan

This type of machine is designed for minimal maintenance; however always observe Maintenance schedule set out
below.
FREQUENCY COMPONENT
Every Machine
day
Every Blade
day
Every 2 Pneumatic circuit.
weeks
Every 12 Supports
months
Every 12 Gear couplings
months
Every 3 Blade and contrast bars
months
WARNING!
Gears reduction unit are lubricated with "permanent" type synthetic oil and therefore do not require lubrication.

7.2.2. Maintenance plan of safety devices

The periodical control of the "SAFETY DEVICES" listed in the table is required.
FREQUENCY COMPONENT
Each Upper hood
month
Each Sealing bar
month guards
Each Pushbutton
month EMERGENCY
Record of control
Each control of the safety devices must be recorded, indicating the data and result of the control performed:
date of check, inspector, result.
Reporting fault
Should a fault be detected, contact the Assistance Service of the Supplier for its restoration.
OPERATION
Remove all residue for product processing which may impair
correct machine operation.
Clean surfaces that come into contact with the film, using
cloths or paper. Never use objects that may damage the
surfaces.
Ensure that there are no leaks from fittings.
Eliminate all condensate formed in the filter unit.
Carry out lubrication with grease type:NLGI 2.
Ensure sufficient lubrication.
Check the condition of the adhesive teflon strips and silicon
plate.
OPERATION
 Opening of upper hood and rear door (both in manual and
automatic mode).
 Check the consequences:
 luminous and acoustic alarm, the machine blocks.
 Movement of guards placed around sealing bar near four
sensors (in manual mode)
 Check the consequences:
 luminous and acoustic alarm, the machine blocks.
 Activation of emergency button (manual and automatic
mode)
 Check the consequences:
 luminous and acoustic alarm, the machine blocks.
40
GB