Minipack-Torre Pratika 56CS Instructions Pour L'installation, L'emploi Et L'entretien page 34

Chapter 6. Machine adjustment and setting up GB
The following is the list of the variables that can be set in the AUTOMATIC program:
Adjusts the quantity of film to leave in front of the pack.
Values: 0 ÷ 300. Default: 25.
Adjusts the quantity of film to leave behind the pack.
Values: 0 ÷ 900. Default: 50.
Adjusts the sealing time.
Values: 0.0 ÷ 3.0. Default: 1.2.
Adjusts the side bar (long) sealing temperature.
Values: 0 ÷ 230. Default: 185.
Adjusts the front bar (short) sealing temperature.
Values: 0 ÷ 230. Default: 185.
Adjusts the conveyor belts speed from 6m/min. to 30m/min.
Values: 0 ÷ 100. Default: 100.
This function enables the operator to select the pack reader photocell.
Values: O (horizontal), V (vertical), O+V (horizontal + vertical). Default: O.
Allows delaying film advancement after photocell reading.
Values: 0 ÷ 250. Default: 0.
Allows to move the "product end" reading the set space.This measure must be compensated
with the REAR FILM function (if set).
Values: 0 ÷ 100. Default: 0.
Allows to adjust film loosening after the sealing bar (recommended with packs higher than
100mm). Possibility of disabling the function (lower than 1 is OFF).
Values: 1 ÷ 250. Default: OFF.
Allows to ease film tension on the triangles, delaying the stop of the unwinder (recommended
with products up to 100mm high).
Values: 0.00 ÷ 1.00. Default: 0.02.
32