Mafell PSS 3000 Notice D'emploi Et Liste Des Pièces Détachées page 37

Defect
Saw assembly stops while cutting is in
process
Saw blade jams as saw assembly is
advancing
Burn marks on kerfs
Chip ejection blocked
8 Optional accessories
Cross fence (cutting width fence)
CT saw blade wrapped 160 x 1.8 x 20 mm, 16 teeth
CT saw blade wrapped 160 x 1.8 x 20 mm, 24 teeth
CT saw blade wrapped 160 x 1.8 x 20 mm, 32 teeth
CT saw blade wrapped 160 x 1.8 x 20 mm, 56 teeth
Cause
Mains failure
Selected speed of forward momentum
too high
Selected speed of forward momentum
too high
Blunt saw blade or saw blade not
suitable for the material
Tension in the workpiece
The saw blade used is unsuitable for
the task or blunt
Speed of forward momentum not high
enough
Wood is too damp
Cutting without chip / dust extraction
External chip / dust extraction too
weak
-37-
Elimination
Check mains back-up fuse
Reduce speed of forward momentum
Reduce speed of forward momentum
Immediately stop forward momentum
by releasing the key and stop
machine. Remove saw assembly from
the workpiece and replace the saw
blade
Riving knife / splitter not available, in
contradiction to regulations. Stop
system as described above and under
any circumstances use riving knife /
splitter
Replace saw blade
Increase speed of forward momentum
Use external chip / dust extraction, e.g.
portable dust extractor
Use stronger external chip / dust
extractor
Before switching on again,
remove connecting hose
between chip outlet, saw
assembly and chip canal and
clean it
Ref. No. 203 353
Ref. No. 092 539
Ref. No. 092 533
Ref. No. 092 552
Ref. No. 092 553