B42. Mains Connection
You can connect the Digital Jockey 2 Master Edition's mains adapter to this connection.
B43. On/Off Button
With this button ou can turn the Digital Jockey on and off respectively.
B44. USB Port
Connect your USB cord to this input.
B45. Audio Output (Master 1)
Connect your main sound system via RCA cord (asymmetrical) or 6.3 mm jack (symmetrical) to this
output.
B46. Audio Input
An external sound source (e.g. CD player, turntable) can be connected to this input.
B47. Phono/Line Switch
Depending on the connected sound source you can de-/activate the phono pre-amp.
B48. Phono/Line Routing Switch
Via this switch you determine whether the Phono/Line Input -B46- should be directly routed to the
master output or through the software.
NOTE! When the switch is in the SW (Software) position, it is possible to to route the phono/line
sources to a virtual deck in Traktor. Moreover you may record with a software and digitalize the
recording.
B49. MIdI/Phono/Line Switch
Via these switches you can dtermine whether the relative channel should be used as MIDI or phono/
line channel.
NOTE! Please also refer to chapter 6 Stand Alone / Software Operation on page 28.
B55. GNd Grounding Screw
Connect the grounding cord of your turntable to this connection.
B56. Booth Output (Master 2)
Here you may connect your main sound or monitoring system or you may use the output
B57. Mic Routing Switch
Via this switch you can determine whether the microphone signal -B35- should be routed directly to
the master output or through the software.
27