Stand Alone / Software Operation - Reloop Digital Jockey 2 Master Edition Mode D'emploi

6. STANd ALONE / SOFTWARE OPERATION

Your Reloop Digital Jockey 2 – Master Edition is more than just a MIDI controller with integrated 24
bit/96 kHz audio interface. It is possible to use it as analogue stand alone mixer, completely inde-
pendent from a software.
Example 1: Stand Alone Operation
Connect a CD player to the Audio Input 1 or a turntable to the Audio Input 2 -B46- on the rear side
of the Digital Jockey. Make sure to connect your turntable's grounding cord to the GND Grounding
Screw -B55-.
For a turntable put the Phono/Line Switch -B47- in the PH (phono) and for a CD player in the LN
(line) position.
In order to be able to use the Digital Jockey 2 Master Edition in stand alone mode the Phono/Line
Routing Switch -B48- has to be in the MST (Master) position. This way the audio signals of the CD
player and turntable are routed through the mixer section to the audio output (Master 1, B45) and
to the Booth Output (Master 2, B56).
The Digital Jockey now has to recognise that you would like to control the turntable and CD player
via the mixer section. On the front side of the Digital Jockey the MIDI/Phono/Line Switch -B49- has
to be in the PH/LI position.
Just like with an analogue mixer you now have full control of the crossfader, linefader, EQ adjust-
ments, monitoring functions, and gain adjustments.
Example 2: Software Operation
You wish to only control Traktor via the Digital Jockey 2 Master Edition.
On the front side put the MIDI/Phono/Line Switch -B49- to the MIDI position. All controller elements
that you can see on the Digital Jockey are now at your disposal in Traktor.
Example 3: Stand Alone/Software Operation
You would like to control an external device, such as tunrtable or CD player, as well as Traktor via
your Digital Jockey.
Connect an external playback device to a channel of your choice as described in „Example 1: Stand
Alone Operation", in order to be able to use it in an analogue way. Put the second channel to the
MIDI position as described in „Example 2: Software Operation", in order to be able to fully use it with
Traktor. This way it is possible to reasonably combine analogue and digital mixing.
NOTE! Input Routing
The Audio Inputs -B46- of your digital Jockey 2 Master Edition are assigned as follows:
Input1
Input2
MIC
28
IN 1 / 2
IN 3 / 4
IN 5 / 6