Reloop CONTOUR Controller Edition Mode D'emploi page 26

ELEmENt FuNctION
T10
T11
T12
T13
T14
T15
T16
T17
T18
T19
T20
T21
26
Effect parameter <advanced E.>
In Advanced Effect Mode the parameters
can be changed quickly hereby.
dry/wet Fader <chained E.>
If Chained Effect Mode is used the single
effects can be controlled via the faders.
NOtE!
In traktor LE in chained Effect mode
only the first parameter is available.
FX On Button <advanced E.>
Activates the Advanced FX Section cor-
responding to the deck. (Deck A --> FX1,
Deck B --> FX2, Deck C --> FX3, Deck D
--> FX4)
Effect reset Function <advanced E.>
In Advanced Effect Mode the effect can
be reset hereby.
FX 1 On <chained E.>
Activates/deactivates the first effect in
Chained Effect Mode.
Effect Button 1 <advanced E.>
Activates/deactivates the Effect Button
1 in Advanced Effect Mode.
FX 2 On <chained E.>
Activates/deactivates the second effect
in Chained Effect Mode.
Effect Button 2 <advanced E.>
Activates/deactivates the Effect Button
2 in Advanced Effect Mode.
FX 3 On <chained E.>
Activates/deactivates the third effect in
Chained Effect Mode.
Loop Length
Turning the encoder varies a set loop's
length.
By pressing the encoder the Loop Acti-
ve function is activated/deactivated.
Loop Shift
By turning the encoder a set loop can
be shifted.
Simultaneously pressing and tur-
ning the encoder determines the
movement's range.
Filter
Regulates the filter effect for the active
deck. In the zero position the filter will
be deactivated automatically.
pan (Balance) controller
Herewith you can adjust the volume
division for the left and right channel.
The zero position corresponds to an
equal level on both channels.
autoloop Function
Sets an automatic loop with the adjus-
ted loop length (-T15-), without having
to manually set the ending point.
reloop Function
Jumps to the last set loop and reacti-
vates it.
Beat Jump Backward
Carries out a beat jump opposed to the
playback direction.
FuNctION wItH actIvatEd SHIFt -t29-
Equalizer controller
By moving the fader the equalizer's parame-
ters can be adjusted. The first fader from the
left controls the high frequencies, the second
fader controls the mid frequencies and the
third fader controlls the low frequencies that
are audible in the following.
Fine pitch controller
Herewith the current deck's pitch fader can be
adjusted exactly.
tempoBend control
Allows the temporary acceleration (clockwise)
or deceleration (counterclockwise) of a track.
cue mix Fading
Via the Cue Mix Fader a pre-mix can be simula-
ted in your headphones. When to the right the
master signal is audible, when to the left the
cue signal is audible.
master volume
Adjusts the master volume.
Loop In/Set cue Button
Manually sets the starting point of a loop.
Simultaneously a cue point will be set.
Loop Out Button
Manually sets the ending point of a loop.
Now the deck is in a loop mode, the selected
sequence is permanentely repeated.
Pressing the button again will end the loop
mode.
Left-Sided GrId-Shift
Shifts the grid that Traktor puts over the bass
line a step to the left.