Fisher & Paykel RX216 Serie Instructions D'installation Et Guide De L'utilisateur page 45

Ice and water
Problem
Ice maker is not
producing ice.
Water filter
indicator light is on
(red).
Possible causes
Ice maker arm is up.
Household water supply is
not reaching water valve.
Copper tubing has kinks.
Water pressure is too low.
Check freezer temperature.
Ice bin is not installed
properly.
Improper water valve was
installed.
Water filter needs to be
replaced.
Filter indicator sensor
needs to be reset.
Troubleshooting
What to do
Confirm ice maker arm is down. See
automatic ice maker, page 25.
See connecting the water supply,
pages 9 – 10.
Turn off water supply and remove kinks.
If kinks cannot be removed, replace tubing.
Water pressure must be between 35 to 100
pounds per square inch to function properly.
A minimum pressure of 35 pounds per
square inch is recommended for refrigerators
with water filters.
See temperature controls pages 12 or 17 to
adjust controls. Freezer must be between 0°
to 2° F (-18° to -17° C) to produce ice.
See ice storage bin, page 25.
See connecting the water supply,
pages 9 – 10. Self-piercing and 3⁄16" (4.7 mm)
saddle valves cause low water pressure
and may clog the line over time. The
manufacturer is not responsible for property
damage due to improper installation or
water connection.
If filter is not available, replace with bypass
cap. See water filter, page 27.
See Filter Status Indicator Light, page 28.
43
EN