Fisher & Paykel RX216 Serie Instructions D'installation Et Guide De L'utilisateur page 36

Care and cleaning
34
Replacing light bulbs
Electric Shock Hazard
Disconnect power to refrigerator before replacing light bulb. After replacing
light bulb, reconnect power.
Failure to do so can result in death or injury to persons.
Caution!
To avoid personal injury or property damage, observe the following:
Before handling, allow light bulb to cool once refrigerator has been
turned off.
Wear gloves when replacing light bulb.
Upper fresh food section
The upper fresh food light bulbs are located behind the front
panel. Reach behind the panel to remove the bulbs.
Lower fresh food section
Push up on bottom tabs of light cover. Rotate cover up and
1
release tabs.
Remove light bulb. Replace bulb with an appliance bulb no
2
greater than 40 watts.
Insert top tabs of light cover into liner slots and snap bottom
3
tabs into liner slots.
Upper freezer section
Remove ice bin by lifting front of bin and pulling out.
1
Remove light shield by pressing the upper right side of the
2
shield and rotating downward.
Remove light bulb. Replace with an appliance bulb no greater
3
than 40 watts.
Rotate the shield upward, press in slightly and snap into place.
4
Replace ice bin by sliding in until bin locks into place.
5
Lower freezer section
Pinch both sides of light cover to remove.
1
Remove light bulb. Replace with appliance bulb no greater
2
than 40 watts.
Pinch both sides of the light cover to snap into place.
3
Ice and water dispenser
On RX216DT7XV2 models a service call is required if light bulb
fails (see page 47).
On RX216CT4XV2 models locate light bulb inside top edge of
1
dispenser frame. Unscrew to remove.
Replace light bulb with a 7-watt, 120 volt bulb.
2
WARNING!
Fig.23 Light in lower
fresh food section
Fig.24 Lights in upper
freezer section
Light Bulb
Location
Fig.25 Ice and water dispenser