Water Filter - Fisher & Paykel RX216 Serie Instructions D'installation Et Guide De L'utilisateur

Water filter removal and installation
Poisoning Hazard
To avoid serious illness or death, do not use the refrigerator where water is
unsafe or of unknown quality without adequate disinfection before or after
use of filter.
Failure to do so can result in death or injury to persons.
Important!
After installing a new water filter, always dispense water for two minutes before removing the
filter for any reason. Air trapped in system may cause water and cartridge to eject. Use caution
when removing.
The bypass cap does not filter water when fitted. Be sure to have replacement cartridge available
when filter change is required.
If water filtration system has been allowed to freeze, replace filter cartridge.
If the water system has not been used for several months, or water has an unpleasant taste or
odor, flush system by dispensing water for two to three minutes. If unpleasant taste or odor
persists, change filter cartridge.
Initial installation
The water filter is located in the upper right-hand corner of the fresh
food compartment.
Open filter housing by pressing the tab at the front end of the housing.
1
Remove the blue bypass cap and retain for later use.
2
Remove the sealing label from end of filter and insert into filter head.
3
Rotate gently clockwise until filter stops. Snap filter cover closed.
4
Reduce water spurts by flushing air from system.
5
Run water continuously for two minutes through dispenser until water
runs steady. During initial use, allow about a 1 – 2 minute delay in
water dispensing, to allow internal water tank to fill.
Additional flushing may be required in some households where
water is of poor quality.
WARNING!

Water filter

Fig.21 Filter housing and
bypass cap
Fig.22 Filter housing
and filter
27
EN