Publicité
Les langues disponibles
Les langues disponibles
Step 4:
Step 4:
Step 4:
Step 4:
Step 4:
Attach the computer (1) at handlebar support (7).
1. Push the plug of the connecting cable (6) projecting from the handlebar
support (7) into the associated socket of the computer (1).
2. Place the computer on the plate provided for it on the handlebar support
(7) and attach it with the screws (28).
3. Push the plug of the pulse cable (5) projecting from the handlebar (4)
into the associated socket of the computer (1).
Step 5:
Step 5:
Step 5:
Step 5:
Step 5:
Installation of saddle (17) at saddle support (21) by using saddle slide
(19). Installation of saddle support (21) at mainframe by using rapid
action lock (44).
1. Push the saddle (17) with saddle bracket into the movable saddle
slide (19) and tight it up in desired position.
2. Place the movable seat post (19) into the holder of saddle post (21),
set it at the desired horizontally position and tighten it by washer (22)
and movable seat knob (23).
3. Insert the saddle support (12) into the provided holder of the main frame
(27) and secure at the desired position by screwing in the rapid-action
lock (44).
(Note: To screw in the rapid-action lock (44), the threaded hole in the
main frame (27) and one of the holes in the saddle support (21) must
be aligned. Furthermore, ensure that the saddle support (21) is not
pulled out of the main frame beyond the marked maximum Position.
The setting of the saddle post can be adjusted as desired later. For
this, the rapid action catch (44) must be loosened by only a few
revolutions, the cap of the lock must be pulled away and the saddle
adjusted. Then secure the new setting by tightening the rapid action
catch.
Step 6:
Step 6:
Step 6:
Step 6:
Step 6:
Installation of the right pedal (68R) and the left pedal (68L) on the
pedal arms (69R+69L).
1. The pedals are marked „R" for right and „L" for left.
2. Screw the right pedal (68R) into the threaded hole on the right hand
side of the pedal arm (69R) and tighten firmly.
(Note: Right and left are specified as viewed seated on the machine
during training. It must also be observed that the threaded part of the
right pedal must be screwed clockwise into the threaded hole of the
pedal crank.)
3. Screw the left pedal (68L) into the threaded hole on the left hand side
of the pedal arm (68L) and tighten firmly.
(Note: The threaded part of the left pedal must be screwed anticlockwise
into the threaded hole of the pedal crank.)
4. Then attach the pedal straps left and right to the respective pedals.
17
Publicité
