Publicité
Les langues disponibles
Les langues disponibles
Assembly Instructions
Assembly Instructions
Assembly Instructions
Assembly Instructions
Assembly Instructions
Remove all the separate parts from the packaging, lay them on the floor
and check that all are there on the basis of the step drawings in these
instructions for assembly and use. Please note that a number of parts have
been connected directly to the main frame and preassembled. In addition,
there are several other individual parts that have been attached to separate
units. This will make it easier and quicker for you to assemble the equipment.
Step 1:
Step 1:
Step 1:
Step 1:
Step 1:
Attach the stabilizer (71+76) at main frame (27).
1. Attach the front foot (71) with the preassembled transport rollers (73)
to the main frame. Do this with the two screws (72), washers (58),
spring washers (79) and cap nuts (74).
2. Attach the rear foot (76) to the main frame (27). Do this with the two
screws (72), washers (58), spring washers (79) and cap nuts (74). After
assembly has been completed, you can compensate for minor
irregularities in the floor by turning the adjusting screw of end cap (75).
The equipment should be set up that the equipment does not move of
its own accord during a training session.
Step 2:
Step 2:
Step 2:
Step 2:
Step 2:
Attach the front post (7) at main frame (27).
1. Hold the handlebar support (7) with the computer cable (6) Against the
main frame holder. Connect the plug for the computer cable (6) coming
out of the bottom of the handlebar support (7) of the computer with the
matching plug for the motor cable (26) coming out of the main frame
(27).
2. Place the handlebar support (7) in the locator provided for it in the
main frame (27). Ensure that the cable connections made are not
squashed. When putting the steering tube in place, push the former
slowly down into the locator in the main frame. Screw the handlebar
support (7) onto the base frame (27) with the screws (16), spring
washers (79) and washers (15).
Step 3:
Step 3:
Step 3:
Step 3:
Step 3:
Attach the handlebar (4) and bottle (13) at handlebar support (7).
1. Guide the preassembled handlebar unit (4) through the upper part of
the handlebar post (7) and close the bracket of handlebar holder (11).
2. Attach the front handlebar cover (10) at the handlebar holder (11) of
handlebar support (7) and screw the handlebar (4) in desired position
at the handlebar post (7) and tighten firmly with spacer (9) and handlebar
screw (8).
3. Put the bottle holder (12) at the handlebar support (7); fix it with two
screws (14) at appropriate position and insert the bottle (13) into the
bottle holder (12).
16
Publicité
