Replacement Of The Security Pin - V.ORLANDI E 40 Serie Instructions De Montage, D'utilisation Et D'entretien

INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
5.7 REPLACEMENT OF THE SECURITY PINS
ATTENTION: Make sure that the drawbar coupling is closed, ie. the
coupling pin (14) is down.
1) Remove the circlip (18b), 'o'-ring (18a), support washer (18c), spring (18d) and
the security pin (18e) (see chapter 7 DISPOSAL on page 30/32);
2) Lubricate the sliding surface of the security pin (18e) with a thin layer of grease;
3) Replace all the parts.
Reassemble the security pin (18e), spring (18d), support washer (18c), 'O'-ring
(18a) and the circlip (18b).
14
DRAWBAR COUPLING E 40
18a
21
18e
18c
18d
18b
PAG.
27/32
CHAP . 5
REV. 00