Replacement Of The Jaw Lock Mechanism - V.ORLANDI Rp10 Instructions De Montage, D'utilisation Et D'entretien

7.2 REPLACEMENT OF THE JAW LOCK MECHANISM

This chapter refers to the figures on pages 30-32/36.
Read the following instructions carefully before any operation:
Please make sure that the jaw (7) and the wedge (11b) are clearly visible
and check to see that the operating handle (19c) is well lodged into its
slot.
1)
Remove the two contrast ring screws (2a) to release the contrast ring (2c);
2)
Remove the worn contrast ring (2c). Dispose as specified in section 9 -
DISPOSAL -page 34/36;
3) Turn out the screw (2a) to remove the pin (2b);
4) Position the fifth wheel plate (8) as shown in the illustration on page 31/36
then proceed with the operations necessary for fifth wheel plate (8) release
from its supports, as per directions given at section 7.1 - FIFTH WHEEL
BEARINGS REPLACEMENT - page 27/36;
FIFTH WHEEL Rp10
INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
8
19c
2a
11b
PAG.
30/36
CHAP . 7
REV. 00
2b
2c
2a
7