Replacement Of The Security Group - V.ORLANDI GA25 Instructions De Montage, D'utilisation Et D'entretien

INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS

5.4 REPLACEMENT OF THE SECURITY GROUP

This operation is for drawbar couplings GA250 and GA251.
ATTENTION: Make sure that the coupling is closed, i.e. the coupling pin
(3) is down.
Unthread the security group (25), see chapter 7 DISPOSAL page 22/24;
1)
Lubricate the sliding surface of the security pin (8) with a thin layer of grease;
2)
Screw the complete new security group tightening it with a torque of 300
3)
Nm using the threadlock (loctite 243).
DRAWBAR COUPLING GA25
8
25
PAG.
20/24
CHAP . 5
REV. A