Replacement Of The Wear Pad Of The Lower Bush - V.ORLANDI E 40 Serie Instructions De Montage, D'utilisation Et D'entretien

INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS

5.5 REPLACEMENT OF THE WEAR PAD OF THE LOWER BUSH

ATTENTION: Make sure that the coupling is closed, ie. the coupling pin
(14) is down.
1)
Remove the 3 screws (21) keeping the washers, remove the mechanism unit
(20a) and the coupling pin (14);
2)
Loosen the 2 screws of the worn wear pad (10a) (see chapter 7
DISPOSAL, page 30/32), remove and replace it;
3) Take care to position the new wear pad (10a) correctly, if necessary replace
also the screws;
N
O
Torque for the screws of the wear pad (10a) 3 Nm
T
E
4)
Fit the coupling pin (14) and the mechanism unit (20a) (see point 3 in chapter
5.2 REPLACEMENT OF THE MECHANISM UNIT AND THE COUPLING PIN, page
22/32).
DRAWBAR COUPLING E 40
10a
PAG.
25/32
CHAP . 5
REV. 00