Operating Instructions - Fisher & Paykel DW24U2I Guide D'utilisation

Controls and starting a wash
Start a wash programme
Open the door to turn ON the dishwasher.
1
– The display will show the wash programme time.
Select desired wash programme on the dishwasher control panel.
2
– The default cycle when you first turn the dishwasher on is Eco.
– After the first wash the dishwasher will remember the last programme used.
Select a wash modifier (for DW24U6I models only). The selected wash modifier
3
indicator will be lit. (see 'Selecting wash modifiers').
Press and close the door to start the wash programme
4
Pause and restart a wash programme
Open the door carefully to pause the programme. The time remaining will flash
1
and the pause beep will sound while the dishwasher is paused.
IMPORTANT!
There is a risk of being sprayed with hot water. Do not fully open the door until
the spray arms have stopped rotating.
Load, remove, or rearrange any dishes if needed.
2
Touch button and close the door in 4 seconds to restart the programme.
3
If the dishwasher is not restarted within 7 minutes, it will then beep until the cycle
is restarted.
Cancel or change a wash programme
Open the door carefully to pause the programme.
1
Touch and hold
2
Touch any button to turn the dishwasher back on, and follow the steps
3
above 'To start a wash programme'.

OPERATING INSTRUCTIONS

to cancel the programme.
EN
7