Fisher & Paykel DW24U2I Guide D'utilisation page 10

Setting delay start
This feature can delay the start of a wash programme by 1 to 12 hours.
Load the dishes, add detergent and close the door.
1
Open the door to turn the dishwasher on.
2
Check that the display shows the wash programme you require.
3
If not, see instructions for 'Changing the wash programme'.
Touch and hold
4
– The 'Delay start' indicator
delay time (hours).
Touch again to increase the number of hours you wish to delay the wash by
5
(1hr – 12hr in hour steps).
Note: Scrolling past 12 hours will exit 'Delay start'.
Press and hold
6
The wash programme will automatically start when the delay time is over.
– The 'Delay start' indicator will be on when 'Delay start' begins its countdown.
– If the door is open when the countdown is finished, the dishwasher will beep
and the display will flash. After 7 seconds the dishwasher will turn off.
Cancel Delay start
Touch until the delay hour is 12h, then press start button again to cancel delay.
8
OPERATING INSTRUCTIONS
will light up and the display will show the
to start delay. The display will countdown in hours.
touch and hold