Fisher & Paykel DW24U2I Guide D'utilisation page 12

Setting wash modifiers (DW24U6I models only)
Using sanitize
The sanitize wash modifier adjusts the wash programme to meet the conditions
required by Section 6, NSF 184 for sanitization to occur.
While sanitize is running, the wash programme is monitored to ensure that these
conditions are met.
IMPORTANT!
For sanitization to occur, the temperature of the water needs to reach 70
z z
Check that all items in the dishwasher are dishwasher safe before running the
sanitize modifier.
If the wash is interrupted or the water supply is turned off during the cycle, then
z z
the heating conditions for sanitization may not be met. You may need to run the
cycle again to ensure sanitization of your dishes.
Only cycles utilising the sanitize wash modifier are designed to meet the
z z
conditions required by Section 6, NSF 184. Other wash programs may not reach
the temperatures required for sanitization to occur. See table on previous page
for wash programs that have sanitize available
At the end of a wash programme with sanitize, always check the display to make
sure that sanitization has been successful.
If sanitization has been successful:
The dishwasher will beep
z z
will show in the display
0
After 30 seconds the display will turn off.
If sanitization has not been successful:
An alert will sound
z z
An alert code will show in the display
z z
The sanitize indicator will not be lit.
z z
10
OPERATING INSTRUCTIONS
C/158 F.
0 0