Radiant Assembly - Fisher & Paykel DCS BGC48-BQAR Guide D'utilisation

INSTALLATION

RADIANT ASSEMBLY

Before assembling the Radiant assembly check that the radiant
trays have not moved during transit. They should sit securely on
their locating pins in the base of the grill.
RADIANT ASSSEMBLY INSTALLATION:
1. Unpack ceramic rods and remove radiant (Fig. 21) from the unit.
2. Unlock radiant end cap by pushing it up with two fingers (Fig. 22).
3. Place 18 ceramic rods on the radiant (Fig. 23).
4. Lock radiant end cap (Fig. 24).
5. Place the assembled radiant in the unit (Fig. 25).
Note:
In case a ceramic rod breaks:
a) Unlock radiant end cap by pushing it up with two fingers (Fig. 22) or pliers may be used.
b) Replace broken ceramic rod.
c) Lock radiant end cap.
FIG. 22
FIG. 24
Radiant tray
20
FIG. 21
FIG. 23
FIG. 25