Radiant Assembly - Fisher & Paykel DCS BGB 36po Instructions D'installation Et Guide D'utilisation

INSTALLATION

RADIANT ASSEMBLY

RADIANT ASSSEMBLY INSTALLATION:
1. Unpack ceramic rods and remove radiant (Fig. 21) from the unit.
2. Unlock radiant end cap by pushing it up with two fingers (Fig. 22).
3. Place 18 ceramic rods on the radiant (Fig. 23).
4. Lock radiant end cap (Fig. 24).
5. Place the assembled radiant in the unit (Fig. 25).
Note:
In case a ceramic rod breaks:
a) Unlock radiant end cap by pushing it up with two fingers (Fig. 16) or pliers may be used.
b) Replace broken ceramic rod.
c) Lock radiant end cap.
FIG. 22
FIG. 24
18
FIG. 21
FIG. 23
FIG. 25