Radiant Assembly - Fisher & Paykel DCS BFGC-30 Guide D'installation / Guide D'utilisation

INSTALLATION

RADIANT ASSEMBLY

RADIANT ASSEMBLY INSTALLATION:
1. Unpack ceramic rods and remove radiant (Fig.37) from the unit.
2. Unlock radiant end cap by pushing it up with two fingers
(Fig. 38).
3. Place 18 ceramic rods on the radiant (Fig. 39).
4. Lock radiant end cap (Fig. 40).
5. Place the assembled radiant in the unit (Fig. 41).
IMPORTANT:
Placement of the trays in the grill are critical to ensure even cooking performance. Lock radiant end caps must be in
the middle of the grill. See Figure 41.
Note:
In case a ceramic rod breaks:
a) Unlock radiant end cap by pushing it up with two fingers (Fig. 38) or pliers may be used.
b) Replace broken ceramic rod.
c) Lock radiant end cap.
Fig. 38
Fig. 40
23
Fig. 37
Fig. 39
Radiant End
Caps
Fig. 41
EN