Yamaha NP-S303 Mode D'emploi page 43

Network
The Network menu enables you to configure network parameters.
❑
Connection
Enables you to select a network connection method.
Select this option if you connect the unit to a network using a commercially-
Wired
available network cable (Page 19).
Select this option if you connect the unit to a network via a wireless LAN
Wireless
router (access point) (Page 23).
Select this option if you connect your mobile device directly to the unit. For
W.Direct more information, refer to "Connecting a mobile device to the unit directly
(Wireless Direct)" (page 28).
NOTE
• If other MusicCast-compatible devices are connected in Extend mode, "Extend(1)" or "Extend(2)"
will appear. For more information on the Extend mode, refer to page 22.
❑
Information
Displays the unit's network information.
NEW FW Indicates whether an update for this unit's firmware is available (Page 47).
Displays the network connection status of the unit (except for Wireless
STATUS
Direct connection).
Displays the status of the MusicCast Network. If "Ready" appears, you can
MC NET
use the MusicCast CONTROLLER app.
Displays the unit's MAC address. MAC address varies depending on the
MAC connection method (wired LAN connection or wireless LAN/Wireless Direct
connection).
Displays the unit's SSID (only for wireless LAN or Wireless Direct
SSID
connection).
IP Displays the unit's IP address.
SUBNET Displays the subnet mask
GATEWAY Displays the IP address of the default gateway.
DNS P Displays the IP address of the primary DNS server.
DNS S Displays the IP address of the secondary DNS server.
❑
IP Address
Enables you to configure the network parameters (such as IP address).
DHCP
This parameter specifies whether a DHCP server will be used.
A DHCP server will not be used. You must configure network parameters
Off manually. For details, see "Configuring the network parameters manually"
below.
A DHCP server will be used, and it will automatically obtain the unit's network
On (default)
parameters (such as IP address).
Configuring the network parameters manually
1
Select "DHCP".
2
Use the cursor keys (/) to select "Off", and then use the cursor
keys (/) to select a parameter to configure.
IP Specifies the IP address.
SUBNET Specifies the subnet mask.
GATEWAY Specifies the IP address of the default gateway.
DNS P Specifies the IP address of the primary DNS server.
DNS S Specifies the IP address of the secondary DNS server.
3
Use the cursor keys (/) to select the edit position.
IP
Address1••192›
(Example: IP address setting)
Use the cursor keys (/) to select a segment to edit.
4
Use the Cursor keys (/) to change the value.
5
Press SETUP to complete the setting.
43
En