Tecno-gaz ONYX B 7.0 Mode D'emploi page 86

ENGLISH
Reading of the T2 probe during sterilization
A 653
A 661
A 662
Error for failed pressure achievement during
A 701
the first two phases of the warm-up
Error for failed pressure achievement during
A 711
Reading of the T1 probe during sterilization
A 751
Reading of the T2 probe during sterilization
A 753
Temperature of the 121°C cycle out o the
A 781
Temperature of the 134°C cycle out o the
A 782
Errors of out of maximum time during the first
A 801
Errors of out of maximum time during the last
A 811
A 901
Cycle interrupted due to power supply failure
It's need to make a SD CARD periodic backup.
In the event of one of the alarms persisting after some time, consult technical
assistance.
40
above the maximum limit
Error in the probe reading
Error in the probe reading
the third phase of the warm-up
below the minumum limit
below the minumum limit
maximum limit
maximum limit
phases of discharge
phase of discharge
- Let cool the room
- Reset and restart the system
- Reset and restart the system
- Reset and restart the system
- Reset and restart the system
- Reset and restart the system
- Reset and restart the system
- Reset and restart the system
- Let cool the room
- Reset and restart the system
- Let cool the room
- Reset and restart the system
- Clean the filter in the room
- Reset and restart the system
- Clean the filter in the room
- Reset and restart the system
- Check the power supply
system of the machine and of
the room.
- Reset and restart the system