Tecno-gaz ONYX B 7.0 Mode D'emploi page 47

1. INTRODUCTION
2. USE AND DESTINATION OF USE OF THE AUTOCLAVE
3. SAFETY
3.1
SAFTY MARKING
3.2 SAFETY DEVICES
3.3 SAFETY NOTES
3.4 DISPOSAL
4. TECHNICAL DATA
5. OUTPUTS AND INDICATORS LIST
6. UNPACKAGING
7. ACCESSORIES
8. INSTALLATION
9. PROGRAMMING DISPLAY
10. USE INSTRUCTION
10.1 TURNING ON THE AUTOCLAVE AND BAROMETRIC ALIGNMENT
10.2 CLEAN WATER TANK MANUAL LOAD
10.3 CHARACTERISTICS OF THE WATER TO BE USED
10.4 LOADING OF THE MATERIALS INTO THE AUTOCLAVE
10.5 STARTING THE STERILIZATION CYCLE
10.6 END OF THE STERILISATION CYCLE
10.7 UNLOADING OF THE STERILIZED MATERIALS
10.8 DISCHARGING USED WATER
10.9 INTERRUPTION OF A STERILIZATION CYCLE
11. STERILIZATION CYCLES
11.1 CYCLES DESCRIPTION
11.2 CYCLE DIAGRAM
11.3 READING OF THE CYCLE REPORT
12. SOFTWARE VISUALIZATION CYCLES
13. AUTOCLAVE CHECK TEST
13.1
CHEMICAL INTEGRATORS
13.2 BIOLOGICAL INTEGRATORS
13.3 BOWIE & DICK TEST
13.4 HELIX TEST
13.5 VACUUM TEST
14. OSMOSI SYSTEM INSTALLATION
15. MAINTENANCE
15.1 TECHNICAL AUTHORIZED ORDINARY MAINTENANCE
16. ALARM MESSAGES
INDEX
ENGLISH
1