Yamaha RX-V1500 Mode D'emploi page 72

REMOTE CONTROL FEATURES
2
Press an input selector button to select the
source component you want to set up.
A B INPUT MODE SLEEP
PHONO TUNER CD MULTI CH IN
V - AUX
CBL/SAT MD/TAPE CD-R
DTV VCR 1 DVR/VCR2 DVD
3
Press and hold LEARN for about 3 seconds
using a ballpoint pen or similar object.
The library name (ex. "L:DVD") and the selected
component name (ex. "DVD") appear alternately in
the display window.
LEARN
y
If you want to setup for another component, press the input
selector button or SELECT k/n to select the component.
Notes
• Be sure to press and hold LEARN for at least 3 seconds,
otherwise the learning process will start.
• If you do not complete each of the following steps within
30 seconds, the setting mode will be automatically
canceled. In this case, press LEARN again.
If you want to change a library (component
category), press l / h. You can set a
different type of component.
Library choices: L:DVD, L:DVR, L:LD, L:CD,
L:CDR, L:MD, L:TAP (tape), L:TUN (tuner),
L:AMP , L:TV, L:CAB (cable), L:SAT (satellite),
*
L:VCR
*
The amplifier library (L:AMP) code is preset to "AMP1"
(2000) in order to operate this unit. However, you can
switch by entering one of the following 3 codes if
necessary.
Function
AMP1 To operate this unit.
To operate
features. (U.S.A., Canada, U.K.,
AMP1Z
Europe and Australia models
only)
To operate other manufacturers'
NO
receivers / amplifiers using this
unit's remote control.
70
Code
2000
ZONE 2 or ZONE 3
2001
2004
4
Press ENTER.
The four-digit code set for the selected component
appears in the display window.
Note
"0000" appears in the display window if no code has been
set.
5
Press the numeric buttons to enter the four-
digit remote control code for the component
you want to use.
For a complete list of available remote control codes,
refer to "LIST OF REMOTE CONTROL CODES" at
the end of this manual.
STEREO HALL
1 2
ENTERTAIN
MUSIC
5 6
THX STANDARD
9 0
6
Press ENTER to set the number.
"OK" appears in the display window if setting was
successful.
"NG" appears in the display window if the setting
was unsuccessful. In this case, start over from step 3.
y
If you continuously want to set up another code for another
component, press the input selector button or SELECT k/n
to select the component, then repeat steps 4 through 6.
7
Press LEARN again to exit from the setup
mode.
LEARN
JAZZ ROCK
3 4
TY THTR MOVIE
7 8
EXTD. SUR
+10 ENT.