Setting Up; Connecting The Pads - Yamaha DTXPRESS III Mode D'emploi

Setting Up

To prevent electric shock and damage to the devices, make sure the power is switched OFF on
the DTXPRESS III and all related devices before making any connections to the DTXPRESS III's
input and output jacks.

Connecting the pads

Referring to the illustration shown below, connect the output cable from each pad to each Trigger Input Jack located on the rear panel of the
DTXPRESS III.
The Trigger Input Jacks are all labeled (1 KICK, etc.) so make sure you connect each pad to its corresponding Trigger Input Jack.
The hi-hat drum pad clamp
can also be attached to
this arm.
Caution)
A cable equipped with a
stereo plug is required
when connecting the
Hi-Hat Controller.
10
Standard set
to 7 CRASH1
to 8 HI HAT
to 2 SNARE
to HI HAT CONTROL
to 3 TOM1 to 4 TOM2
to 1 KICK
to 6 RIDE
to 5 TOM3