Stopping The Engine - Shindaiwa M243S Manuel D'utilisation

Engine operation
Engine warm-up
Starting a warm engine
1. Ignition switch
2. Throttle trigger

Stopping the engine

1. Ignition switch
3. Throttle trigger lockout
2. Throttle trigger
6. Checking that the area around you is safe, hold the position
closest to the engine firmly as shown in the illustration, pull-
ing several times on the starter grip.
7. If you hear an explosion-like sound and the engine stops im-
mediately, move the choke lever to the "Run" position and
continue pulling on the starter grip to start the engine.
8. If the engine starts immediately when you carry out the in-
structions in step 6, above, return the choke lever gently to
the Open position.
9. Leave the engine to warm up at idle speed for a while.
IMPORTANT
If the engine fails to start after several attempts with the choke
in the closed position, the engine may be flooded with fuel.If
flooding is suspected, move the choke lever to the open posi-
tion and repeatedly pull the recoil starter to remove excess fuel
and start the engine. If the engine still fails to start, refer to the
troubleshooting section of this manual.
1. Once the engine starts, allow it to warm up for 2 to 3 minutes
at idling (i.e. low speed).
2. Warming the engine helps to lubricate its internal workings
more smoothly. Allow the engine to warm up fully, especially
when it is cold.
1. Move the ignition switch to the Start position.
2. Make sure that the throttle trigger is at the idle speed posi-
tion.
3. Check that the choke lever is in the Open position.
4. If no fuel is visible in the purge bulb, alternately press and re-
lease the purge bulb until the fuel is sucked up into it.
5. Checking that the area around you is safe, hold the position
closest to the engine firmly, and pull on the starter grip to
start the engine.
1. Move the throttle trigger to the idle speed position and set
the engine to idling (i.e. low speed), keep it idling for about 2
minutes.
2. Move the ignition switch to the Stop position.
3. In the event of an emergency, stop the engine immediately
using the ignition switch.
4. If the engine fails to stop, move the choke lever to the "Cold
Start" position. The engine will stall and come to a halt (an
emergency stop).
∗ If the engine fails to stop when the ignition switch is used, have
the ignition switch checked and repaired by your dealer before
you use the product again.
18