Adjusting The Balance - Shindaiwa M243S Manuel D'utilisation

Before you start
1. Press latch
1. Cable adjuster

Adjusting the balance

Adjusting the shoulder harness
1. Shoulder harness
2. Lock nut
Removing a tool attachment
1. With the unit on a clean, flat surface, loosen the coupler
screw. The spring-loaded coupler protector should pop up.
2. Press down on the latch with your finger or thumb. This re-
leases the coupler lock.
3. Pull the tool assembly out of the coupler.
Adjust throttle lever free play
The throttle lever free play should be approximately 4-6 mm.
Make sure that the throttle lever operates smoothly without bind-
ing. If it becomes necessary to adjust the lever free play, follow
the procedures and illustrations that follow.
1. Loosen the air cleaner cover knobs and remove the air
cleaner cover.
2. Loosen the lock nut on the cable adjuster.
3. Turn the cable adjuster in or out as required to obtain proper
free play 4-6 mm.
4. Tighten the locknut.
5. Reinstall the air cleaner cover.
1. Hook the harness hook to the hanger on the outer tube.
2. Wear the shoulder harness so that the hook stays at your
right hand side.
3. Adjust the length of the shoulder harness so that you can
hold and operate the machine comfortably.
14