Before You Start; Assembly - Shindaiwa M243S Manuel D'utilisation

Before you start

Assembly

Read the operator's manual carefully to ensure that you assemble the product correctly.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
IMPORTANT
The terms "left", "left-hand", and "LH"; "right", "right-hand", and "RH"; "front" and "rear" refer to directions as viewed by the op-
erator during normal operation.
1. Cushion
1. Handle
2. Square nut
3. Barrier bar
4. Bolt
WARNING
2. Projetion tab
5. Cushion
6. Clamp
7. Outer tube
Before you start
Prior to assembly
Before assembling, make sure you have all the components
required for a complete unit:
Engine/Outer tube assembly
Shoulder harness
Handle (with cushion)
Barrier bar
Bolt (1 pcs)
Square nut (1pcs)
Kit containing this owner's/operator's manual and tool kit for
routine maintenance. Tool kits vary by model and may in-
clude a hex wrench, scraper, and a spark plug/screwdriver
combination wrench.
Handle
1. Check the inserted cushion into the handle as shown fitting
the projection tabs into the corresponding holes on the han-
dle.
NOTE
Make sure the clamp is on the outer tube.
12