Shindaiwa M243S Manuel D'utilisation page 15

1. Arrow
1. Tube assembly
2. Latch protector (ex-
tended)
3. Latch
4. Locking hole
1. Coupler
2. Latch protector (low-
ered)
5. Coupler screw knob
6. Coupler
7. Tool assembly
3. Coupler screw knob
Before you start
2. Insert the barrier bar into the clamp on the outer tube, mak-
ing sure the hole of the clamp is visible through the cutout on
the barrier bar.
3. Position the handle at the best position for operator comfort.
Push down hard to pop handle housing over tube.
4. Install square nut in handle and use bolt to fasten and tighten
against handle.
IMPORTANT
Make sure the arrow on the handle points towards gear case.
Installing a tool attachment
1. Place the Multipurpose Tool Carrier and the Tool Assembly
on a clean, flat surface so that both assemblies fit end to
end. This assembly should be facing up and the tool assem-
bly should be positioned with the locking hole in the tube end
facing up.
Keep the open ends of the tubes clean and free of impurities.
2. Slip off the protective covers from the ends of both tubes,
and loosen the coupler screw knob.
3. Insert the tool assembly into the coupler, with the tool decal
facing up, until the line of the decal is flush with the end of
the coupler.
4. Twist the tool assembly back and forth until you are sure it
snaps in place by the coupler latch.
5. When the two tube halves are locked together, press down
on the spring-loaded latch protector and tighten the coupler
screw knob.
13
CAUTION