Tunturi Pure U bike 10.1 Mode D'emploi page 7

Assembly step D
• Lead the wires for hand pulse
reading through the hole towards the
display assembly opening.
Remark:
Avoid the wires to damage during
assembly..
• Fit the handlebar to the upright tube
by using the shown hardware..
Remark:
First put all screws/ bolts in correct place
before tightening them fully.
Assembly step E
• remove the 4 assembly screws from
the consoles rear cover.
• Fix the console to the console
bracket.
• Guide the hand pulse wires coming
from the handlebar and data cable
coming form upright tube through the
console bracket hole.
• Connect the hand pulse wires and
data cable with the console.
• Fix the console bracket to the upright
tube.
Remark:
Avoid the wires to damage during
assembly
O w n e r ' s m a n u a l
Assembly step F
• Fix the bottle holder to the upright
tube.
Assembly step G
• Fix the seat the seat slider already
pre assembled to the seat tube.
Remark:
before using your bike after complete
assemly make sure the seat is tightened
fully and is correctly aligned.
Assembly step H
• Slide the seat tube into the main
frame.
GB
•
P u r e 1 0 . 1
7