Publicité
Les langues disponibles
Les langues disponibles
Connection of the Ethernet cable:
- If a Cat5 Ethernet cable is use to carry the NTP signal then it is possible to connect it directly to
the clock using the wall bracket ref: 981006.
- If a Cat6 Ethernet cable is use to carry the NTP signal then we recommend that you connect
that cable to an intermediate female RJ45 connector (in red in the illustration) and connect the
clock with a flexible Male RJ45 to Male RJ45 cable (not supplied). The connector must not
be placed below of the movement because it would prevent the clock from being placed flush
against the wall or from locking on its bracket. The wall bracket 981006 can be used in case.
- In order to ensure the water-tightness of the Profil 940 NTP, the Ethernet cable is supplied with
the RJ45 connector off. To crimp the RJ45 connector follow the wiring diagram:
1 2 3 4 5 6 7 8
RJ45
20
EN
1 2 3 4 5 6 7 8
RJ45
Publicité
Chapitres
