Oven Light(S); Oven Door; Storage Drawer; Warming Drawer - KitchenAid ARCHITECT II Serie Guide D'utilisation Et D'entretien

OVEN RACKS
Cleaning Method:
Self-Cleaning cycle:
See "Self-Cleaning Cycle" first. Remove racks or they will
discolor and become harder to slide. If this happens, a light
coating of vegetable oil applied to the rack guides will help
them slide.
Steel-wool pad
STORAGE DRAWER (on some models)
Make sure drawer is cool and empty before cleaning.
For more information, see "Storage Drawer" section.
Cleaning Method:
Mild detergent
WARMING DRAWER (on some models)
Make sure drawer is cool and empty before cleaning.
Cleaning Method:
Mild detergent (for both)
KitchenAid ® Stainless Steel Cleaner and Polish (sample
included):
See "Assistance or Service" section to order.

Oven Light(s)

The oven light is a standard 15-watt appliance bulb. It will come
on when the oven door is opened. The light will not work during
the Self-Cleaning cycle (on some models). On some models,
when the oven door is closed, press OVEN LIGHT to turn the light
on or off.
To Replace:
Before replacing bulb, make sure the oven and cooktop are cool
and the control knobs are off.
1. Unplug range or disconnect power.
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb and bulb cover by turning clockwise.
5. Plug in range or reconnect power.

Oven Door

For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1. Open oven door all the way.
2. Flip up the hinge latch on each side.
3. Close the oven door as far as it will shut.
4. Lift the oven door while holding both sides.
Continue to push the oven door closed and pull it away from
the oven door frame.
To Replace:
1. Insert both hanger arms into the door.
2. Open the oven door.
You should hear a "click" as the door is set into place.
3. Move the hinge levers back to the locked position. Check
that the door is free to open and close. If it is not, repeat the
removal and installation procedures.

Storage Drawer

The storage drawer can be removed. Before removing, make sure
drawer is cool and empty.
To Remove:
1. Pull drawer straight out to the first stop.
2. Lift up the back of the drawer and pull out.
To Replace:
1. Fit the ends of the drawer rails into the guides in the cavity.
2. Slide the drawer closed.

Warming Drawer

(on some models)
Remove all items from inside the warming drawer, and allow the
warming drawer to cool completely before attempting to remove
the drawer.
To Remove:
1. Open drawer to its fully open position.
2. Locate the black loops on both sides of the drawer.
A
A. Loop
23