Auto Setup; General Control; Input Function; Display Brightness Control - Pioneer X-CM66D Mode D'emploi

04 Getting started

Auto Setup

If the access point has an automatic connection button, you
can connect without entering a password.
1 Press MENU on the remote control.
2 Press / to select "Wi-Fi Setting", and
press ENTER.
3 Press / to select "Auto Setup", then
press ENTER.
4 Press the automatic setting button of the
access point to be connected.
"Connected" is displayed when the connection is established
and lights.
12
En

General control

Input function

When the INPUT on main unit is pressed, the current
function will change to different mode. Press the INPUT
repeatedly to select desired function.
CD TuneIn
Audio In USB

Display brightness control

Press DIMMER to dims the display brightness. The
brightness can be controlled in four steps.

Volume auto set-in

If you turn off and on the main unit with the volume set to 31
or higher, the volume starts at 30 and sets in to the last set
level.

Volume control

Turn the volume knob towards VOLUME (on main unit) or
press VOL +/– (on remote control) to increase or decrease
the volume.
CAUTION
• The sound level at a given volume setting depends on
speaker efficiency, location, and various other factors.
It is advisable to avoid exposure to high volume levels.
Do not turn the volume on to full at switch on. Listen to
music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing
loss.

Muting

The volume is muted temporarily when pressing the
the remote control. Press again to restore the volume.
Spotify Bluetooth
FM DAB
on