Publicité
Les langues disponibles
Les langues disponibles
DETERGENT
REPLACEMENT
CLEANING
OF
PUMP HOSES
Guidelines to be followed when replacing
detergent :
- If you leave the machine without detergent,
crystallization arises due to the formation of air
bubbles
- Set up again detergent pump hose anytime you
use a new detergent
- The whole system consists of a container,
dosage hoses and detergent pump hoses and
must be cleaned before using a new detergent.
- Call on your authorized technical assistance to
fulfil the necessary operations to obtain a good
cleaning result.
-
You are recommended to proceed with the
cleaning of the dosage hoses and the detergent
pump with water once a month.
Failure to comply with these guidelines will
render
this
guarantee
disclaims any liability for consequential
damage on the product.
You can clean yourself the dosage hoses and
the detergent pump with water.
Guidelines:
A
-
Disconnect the suction hose from the
detergent can.
AND
THE
DETERGENT
invalid.
Lamber
B
-
Connect the suction hose to a new water
recipient.
C
-
Switch the Self-cleaning cycle on (see
paragraph page 9)
D
– Once self-cleaning is finished, connect the
suction hose to the detergent can.
WARNING:
chemical
dosage guidelines.
When using chemical products you must wear
personnal protection equipment, gloves and
protection glasses. Do not mix different
detergents together.
WARNING: Replace one a year the peristaltic
pumps suction pipe cod. 0500094 (see
draw)
Respect
security
and
Publicité
